Designed to meet the high requirements of
the electronic assembly industry.
Leaves a lead-end of a lower altitude and
smaller surface area, important for solderability
and connection coverage.
Unique design with an extremely wide cutting
range to suit an unmatched variety of uses.
Micro-Bevel® Cut
The Flush Cut
"Pinches" the leads at a lower altitude
than Micro-Bevel® cutters.
Leaves an even narrower and shorter taper
along the "pinch", reducing the surface
area even further.
The reason for using a Lindstrom Flush cutter
rather than the Micro-Bevel®
is to meet a slightly tighter specification
for the cut lead-end or to gain a more flush
result to a board, component, or part.
Flush Cut
The Ultra-Flush®
Cut
Designed to eliminate the "pinch"
other cutters make.
With the exception of Lindstrom's own Micro-Bevel®
and Flush cutters, the Ultra-Flush®
will outlast any other "flush" or
"shear" type of tool and still match
competitive cutting ranges.
Perfect for use in close tolerance electronic
and medical device assembly.
